A lot of Glenview houses don't have one duct system — they have two. Teardown rebuilds and additions often run a basement furnace for the main floor and a separate attic unit for the bedrooms. That's twice the ductwork collecting dust, and the attic side is usually the one nobody has looked at since the drywall went up.
Glenview's setting adds its own load. Mature oaks, maples and cottonwoods line streets like Chestnut, Lake and Glenview Road, so spring pollen and summer seed fluff get pulled straight into return grilles. Homes closer to the North Branch of the Chicago River and the Middle Fork deal with damp basements, which is where most return trunks run. And the townhomes and single-family houses built at The Glen in the early 2000s are now around twenty years old — many on their original, never-cleaned ductwork.
Jump to: What we clean · Common Glenview problems · Service area
See both systems on camera before deciding anything
In a Glenview home we inspect each system separately — basement supply and returns, then the attic unit if you have one. You see the inside of your ducts on screen while we're there, and you decide based on what's actually in them. After the cleaning, we run the camera through the same lines so you can compare.
Every zone, every trunk — not just the registers
Attic ducts take a different approach than basement ducts: flex runs, tight joist bays and insulation all around them. We connect our HEPA negative-pressure equipment to each system in turn, work every branch line back to the trunk, and clean the blower compartments on every furnace and air handler, so debris leaves the house instead of moving to another floor.
A whole-house price, even with two furnaces
You get one number for the full job — both systems, all registers, the blowers — before we start. No surprise charge for the second unit, no per-vent add-ons. If the camera shows your ducts are still in good shape, we'll tell you to wait.